Strange Engineering has been the leader in drag racing brake kits since 1965 and is the only manufacturer of one piece forged steel brake rotors. The one piece design is far superior to common bolt together two piece rotors in weight reduction, strength and longevity. All Strange Pro Race rotors are slotted. Slotting was developed by Strange to minimize warpage, while maximizing weight reduction. Every kit features the sought after 4-piston directional caliper. The directional caliper accomplishes superior bridge bolt strength at only 2.70 pounds. Strange directional calipers feature 1.750" and 1.625" OD stainless steel pistons to assure optimal pad wear and exceptional pedal/handle feel. Every Strange caliper is internally ported and include .100" square o-rings to assist piston retraction. Brake kit weighs only 23.70 lbs. with soft pads.
Designed Specifically For Drag Racing
Rear brake kit for 1957-1964 Oldsmobile housing ends
Brake offset = 2.832 in.
This Strange rear brake kit includes:
Forged One Piece Slotted Steel Rotors
- Superior strength without the concerns of bolts loosening or hats cracking
- Slots improve air flow, assist in warpage prevention, and reduce weight
Four Piston Aluminum Directional Calipers with Stainless Steel Pistons
- Aluminum bodies drastically reduce weight
- Pistons are 1.625? & 1.750? to vary pressure on the pads decreasing pad taper
- Stainless steel pistons are corrosion resistant
- Anti-rattle clips reduce brake pad vibration and noise
Billet Aluminum Caliper Mounts
- One piece design eliminates spacers & bolts that require periodic maintenance
Housing End Stud Kit
- Additional components that are not supplied in most aftermarket systems
Soft Metallic Brake Pads
- Provides the best starting-line cold holding power
- Recommended for vehicles going 150 MPH or less in the 1/4 mile
Note
Brake hoses and lines are not included
Calipers are tapped 1/8 in. NPT and supplied with male 3 AN fittings.
- Position:
- Rear
- Rotor Included:
- Yes
- Rotor Style:
- Slotted surface
- Rotor Construction:
- 1-piece Solid
- Rotor Diameter:
- 11.250 in.
- Rotor Thickness (in.):
- 0.350 in.
- Calipers Included:
- Yes
- Caliper Piston Quantity:
- Four
- Caliper Material:
- Billet aluminum
- Caliper Finish:
- Black Powdercoated
- Parking Brake Provision:
- No
- Minimum Recommended Wheel Diameter (in.):
- 15 in.
- Offset (in.):
- 2.832 in.
- Brake Hoses Included:
- No
- Wheel Bolt Pattern (in.):
- 5x4 1/2 in.-5x4 3/4 in.
- Quantity:
- Sold as a kit.
- Axle Housing Flange Type:
- Oldsmobile/Pontiac (3.500 in. x 2.37 in.)
- Differential Case Design Type:
- Oldsmobile/Pontiac
- Notes:
- Kit includes 1-piece rotors.
- Make:
- Oldsmobile
- Make:
- Pontiac