• Material: N/A
  • Finish: Natural
  • Quantity: Sold as a kit.
Looking to add more support to your 8.8 in. In addition to Team Z's forward brace, they offer a weld on under brace for 8.8" housing.  This kit comes with a pre bent and notched tube to weld to the housing, and a gusset brace to add even more support to the housing. The kit helps in limiting the axle tubes to bend or move under load and higher horsepower. Every piece is cut and bent in ...
Part No: TZM-8.8-BB
  • Material: Aluminum
  • Finish: Natural
  • Quantity: Sold as a kit.
Team Z's Complete Brace Kit comes with both the Forward Brace kit and the Bottom Brace to ensure that you get the most support out of your 8.8" housing. Both kits will limit twisting and bending that may occur with higher horsepower. The front holes by the pinion must be drilled out to 7/16" to accommodate the hardware for the forward brace. Note: The pictures of complete housing do ...
Part No: TZM-8.8-CBK
  • Material: N/A
  • Finish: Natural
  • Quantity: Sold as a kit.
Want to add some support to your 8.8 in. Housing? Team Z now offers a front brace to add support from your pinion! This kit comes weld on tabs that mount to your axle tubes between the control arm brackets, a set of adjustable support bars and hiems, and all the hardware to mount this kit. You must drill out the holes close to the pinion to 7/16" to fit the bolts to these ...
Part No: TZM-8.8-FB
  • Material: N/A
  • Finish: Natural
  • Quantity: Sold as a kit.
Team Z Lower Shock bracket kit for 8.8" housings. Long design for use with coil over shocks, zinc plated brackets, Grade 8 hardware and shock spacers included The kit Includes: 2) 1/4" Weld on Mounts 4) 3/16" Bolt on Mounts 4) 3/8" Bolts 4) 3/8" Nylock Nuts 4) Shock Spacers 2) 1/2" Bolts 2) 1/2" Nylock ...
Part No: TZM-LSM-KIT
  • Material: Aluminum
  • Finish: Natural
  • Quantity: Sold as a kit.
Looking to add more support to your S197 Mustang with a 8.8 in.? Team Z now offers a weld on under brace for 8.8" housing. This kit comes with a pre bent and notched tube to weld to the housing, and a gusset brace to add even more support to the housing. The kit helps in limiting the axle tubes to bend or move under load and higher horsepower. Every piece is cut and bent in house. ...
  • Material: Steel
  • Finish: Natural
  • Quantity: Sold as a kit.
Team Z Rear tunnel brace is designed for your 2005-2014 S197 Mustang. This kit is constructed from 1/4" steel cut on Team Z's water jet in-house. It comes standard with a removable driveshaft loop that is also made from the same 1/4" steel. It adds rigidity to the rear of the car while offering additional safety in the event of drive shaft failure. Each piece comes powder coated in a silver ...